it looks like Fusion 360 runs fine on Linux

I can assure you, it does not.

Do not switch to Linux and expect this project to save you, it is NOT beginner friendly.

It’s great, and I’m sure someone smarter than me could probably get it working, but personally, I failed miserably and switched to OnShape.

Thanks, that was a great answer! I had no idea it was so complicated. I was definitely in the naive camp there.

After covid, this strikes me as a dangerous thing to say. Are you an immunologist and could you expound on this?

deleted by creator

signed, Hugh Mann

My idea is essentially to match the official stand that ships with it, but flip it and put a stand on the “bottom.” I think it’ll be really nice aesthetically but unfortunately it seems like it’s not as simple as just mirroring it. To tell the truth, I’m probably going to end up going this route anyway, but I feel like I have to at least try the hard way first

Thanks, that gives me something to go on! I realise I’m probably taking the hard road but, eh. Worst case scenario is a little wasted time and filament. No one ever learnt doing it the easy way anyway. If I get anywhere I’ll report back

If you’re interested in the plight of those who take the Darién Gap route, and want a less politically motivated source, Bald and Bankrupt went through.

Playlist here and there’s a 4th video as well which is just an interview here.

interior crocodile alligator, I drive a Chevrolet movie the-atre