What are your bed temps for PLA and ASA? Does it still happen if you preheat the bed? If you rotate the print, does the rough spot follow the rotation?
What are your bed temps for PLA and ASA? Does it still happen if you preheat the bed? If you rotate the print, does the rough spot follow the rotation?
He’s daydreaming about going all Gordon Ramsay on the LKML after the photo shoot.
During CPU startup Transmeta’s Dyson “It” style campaign leading to their first product launch, they widely publicized that Linus was on staff.
Ironically you chose a picture of Linus holding a laptop containing the only product he’s famous for shilling.
“fill angle” under infill settings.
Yep. I can get ASA down to 12% with an ambient 50%RH using that method.
There are some models out there for wedges with reverse Bowden fittings so you can keep it cracked open all the time.
Try running your dryer with the lid propped open a bit. Most Sunlu dryers don’t have a way to get rid of the humid air pulled out of the filament.
Then they trip balls, see their life flash before their eyes, and become a space baby. Could be worse.
Most GHz RF designs are a PCB with a bunch of copper sigils and a single transistor.
V.35 or IEEE-488
Nah, this is Apple. It’s got to be the most expensive: Lemo medical grade.
N connector to SMA, and hardline to USB-C.
But one of those chonky third party ones with the buttons on the sides, and have a FireWire cable coming out of there too for that 2003 feel
Sometimes EDID eeproms are writable from i2c-dev… And sometimes VRM configuration ports too…
Correct. We’ve replaced all our incandescent bulbs except for two 60w contractor bulbs in the a hallway that were installed when the house was built 18 years ago. All of the original higher wattage incandescents died within the first couple of years.
The C64 had a notoriously garbage power supply that would eventually cook the machine regardless of how clean your line power is.
A large green pushbutton with a Molly guard labeled “OK” I found in a scrap pile behind the physics building.
Nonfiction oldies that still hold up: The Cuckoo’s Egg by Clifford Stoll and The Soul of a New Machine by Tracy Kidder.
Apple historically can’t or won’t bring mixed signal design in-house. It could be related to patents, standards compliance, or the much more complicated silicon design, DV, and test for analog vs digital. It’s not just the modem either. The bulk of Cirrus Logic’s business nowadays is making audio, haptics, and focus servo chips for Apple, and if Apple ever went vertical with those components Cirrus would collapse overnight. Yet Apple has been buying custom audio chips from them for over 30 years, so obviously this isn’t a new trend.
Thinkpad intensifies
I think your bed is warping slightly as it heats up, which is normal. Set your bed temp to 105 for half an hour before starting your print and see if it still happens. If you have a V0 or other manually levelled printer, get the bed to 105 before levelling.