Wow, this is an incredible guide thanks for showing me

I figured there might be something like this that i hadn’t seen. I’ll look into it tomorrow, i get the feeling this would cause the inconsistency.

I have never bought an ender. I just happen to have one :P

Ah, thank you for the advice and the link!

The falling prints i think have issues in the same spots, there are relatively small patches around the print surface that don’t print very well, though they don’t seem to correspond to the bed leveling screws or anything. Now that i say that I’ll have to check that I’m using the mesh level correctly when i get home.

I’m still using a Bowden type extruder. The extruder itself is a generic aluminum one. My filament is run out of a sunlu dryer by the side of the machine.

I think i actually raised the jerk at one point to reduce the radius on corners, so i can bring that back down again and experiment with acceleration.

I have a glass bed and I’m using the tramming function with the mriscoc firmware to give me depth readings for each of the four screws, and I usually reign them in to about 0.04mm range. Parts close to each other tend to have similar but not the same results, and i think the patches are too small to be from bed leveling, usually only a couple centimeters.

I can redo esteps, i can see what you mean about the overextrusion. I only set my esteps to the number recommended by the manufacturer of my extruder, but i haven’t measured it myself yet, maybe that’s a bit silly of me. Though if that’s the problem then I’m still curious why it’s different in different areas.

I can check out acceleration too, i looked up what acceleration and jerk meant at one point but it didn’t make much sense to me at the time.

If only i knew the truths 😞

Yes, it is good, but this step forward is only the result of an arguably bigger step backward, which is why people are bringing it up.

Not to mention we already had repairable wired headphones that we can’t use now if we get a fairphone.

I think part of the conversation is about how they got rid of the headphone jack shortly before releasing these. While it is good that these exist, it seems like they exist as a result of a popular anti-consumer business choice that people don’t like, and is thus tied to that choice.

Yeah, idk why people are downvoting you so hard. There are some seriously good passive noise cancellation buds out there. Kind of insane when you actually try them.

Steam also gives you the option to archive your games in a format compatible with dvds.

It’s more like wanting to go back to horses and walking because some cars have started driving themselves to the manufacturer to be scrapped in the middle of the night, but i have to agree with you.

Hold on a second, how come every time i look for TPUs i get a bunch of not-for-sale nvidia and Google cards, but this just exists out there and i never heard of it?

Ikr? It’s like they’re counting every act of digital piracy ever to be their lost profits when that’s obviously not the case.

Use prism, it’s a more up-to-date fork of multiMC.

Dead frogs in your area? 😳

I only notice my vpn when I’m gaming with friends. Otherwise video streaming and downloads are unchanged.

M = meters. Mi = miles

You owe us $2

You owe us $4

You owe us $16

You owe us $65536

You owe us $2*10^19729