![](/static/66c60d9f/assets/icons/icon-96x96.png)
![](https://lemmy.world/pictrs/image/23c0d8cc-429d-42ca-a766-fa9ca3a2e060.jpeg)
That might be the best option I have until I finish my Hal9000 project.
That might be the best option I have until I finish my Hal9000 project.
That… Isn’t the worst idea. My HA server is close to all of them, so I would just have to add a RF blaster.
And I thought about the momentary switch, but it would be a PITA to wire it so that the wires were hidden.
I don’t want to have to run wires since our attic is a nightmare (blown in insulation 3ft deep), and I don’t want wires just running in the open.
What I’m looking for really isn’t super complicated. It could easily be done by Lutron or someone making a few small changes to a motion light since they already have the firmware to select shutoff times.
S1 and S2 are only for the activation switch. You connect the actual device that gets controlled to Line Out.
If your setup doesn’t require a physical switch, then nothing gets connected to S1 and S2
I don’t know anything about your device, but would a factory reset be too much of a hassle?
I knew I was over thinking things, and the solution would be a super simple product. Thank you!