The amount of waste and time it takes are downright insulting

I did, check my comment.

Completely new and dried for 24 hours in a dedicated dryer. Thanks.

SOLUTION: runs contrary to common knowledge, but what ultimately helped was:

• INCREASING print speed. The usual recommendation is the slower the better, but at that point, there’s no pressure control over the filament
• ENABLING retraction. Again, usual rec is to disable it for flexibles but turns out it alleviates too much backpressure which leads to filament buckling in the extruder

Also printing hotter than mfg recommends: I printed at 260 (10C over recommended maximum).

Thanks to u/Over_Pizza_2578 for pointing me to the right - opposite to everything else - direction.

Yes, this is probably adding to the situation.

I’m in the same boat. I’d like to have something like this integrated with Home assistant but Grocy is just ludicrously complex. It’s like SAS for your fridge, only more complex. With rude developers who always know better than everyone else.

VM or container? VM is easier and can be usually configured even via Proxmox GUI (Hardware - Add PCI). Various OSes need various levels of effort. Some Linux distros don’t need any more config, Windows on the other hand required a custom GPU ROM on my system to work.

This can be done even with a single GPU, even the built in iGPU.

So you use the free thing wrong, don’t RTFM, vent on internet and then vent some more when corrected? What’s your end game?

Looks like an user error to me. Influx is for long-term storage of history and data, you don’t need it for automation at all.

Absolutely wrong. I have dozens of devices integrated, from a lot of brands, all working. You can of course try to get a turnkey solution from like Loxone, but be prepared to pay thousands of dollars, and good luck adding anything that’s not in their ecosystem. And there’s a lot of that. And what is there is all pretty outdated.

Xiaomi is great and I use a lot of their stuff, but the options for automation are severely limited.

Thanks!

I want that! What is it?